

About hydraulic cylinders...
As the actuator of a hydraulic system, the selection of hydraulic cylinders directly affects the operating efficiency and service life of equipment. Selection must be based on operating conditions, performance parameters, and installation requirements to choose the correct cylinder.
We provide original standard cylinders and customized OEM solutions for customers around the world, which are perfectly suited to large mining equipment such as Komatsu, Carter, Liebherr, etc.
Define the task requirements
Load calculation
Calculate the maximum load the hydraulic cylinder needs to withstand based on the excavator's operation. Typically, a safety margin of 20%-30% should be allowed to prevent overload from causing cylinder deformation or seal failure.
Stroke Requirements
Determine the required effective stroke of the hydraulic cylinder based on the operating scenario, ensuring the stroke meets the limits of operational conditions while avoiding a decrease in stability due to excessive stroke.
Speed requirements
Choosing the appropriate cylinder bore size is crucial; a larger bore results in greater thrust but slower speed. The piston rod diameter affects the return speed, necessitating a balance between thrust and operating speed.
Working pressure
The cylinder pressure must match the pressure of the equipment's hydraulic system. Generally, the rated pressure of the cylinder should be 5%-10% higher than the system pressure to prevent seal damage or insufficient power caused by pressure mismatch.
Flow rate matching
The inlet and outlet dimensions and flow rate specifications of the hydraulic cylinder must match the flow rate output of the hydraulic pump and control valve to avoid energy waste due to excessive flow rate or slow operating speed due to insufficient flow rate.
Mounting Interface
Confirm that the cylinder's mounting method (e.g., eyelet type, flange type, pin type) and the specifications of the connecting threads match the mounting base of the excavator body. This prevents installation difficulties or uneven force distribution caused by incompatible interfaces.
Core component materials and processes
Cylinder block and piston rod
Cylinder blocks made of seamless steel pipe or alloy steel pipe are preferred. Piston rods are made of 40Cr material and are chrome-plated (chrome plating thickness ≥0.05mm) to ensure wear resistance, corrosion resistance, impact resistance and extend service life.
Seals
Seals are crucial for preventing cylinder leaks. Choose seals made of nitrile rubber (NBR) or fluororubber (FKM) that are compatible with different hydraulic oil types (mineral oil, synthetic oil). They must also be resistant to high temperatures (-20℃~120℃) and high pressure. Prioritize seal kits from well-known brands (such as Parker and NOK).


Manufacturing details
Inspect the cylinder block welds for cracks, ensure the piston rod surface is smooth and scratch-free, and verify the uniformity of the cylinder bore chamfer. High-quality hydraulic cylinders undergo tempering, precision honing, and pressure testing to ensure sealing performance and structural strength.
Maintenance aspects
Enhanced protection against high contamination and wear

Cleaning frequency
The piston rod should be wiped from "regularly" to "after daily operation". Because the excavator's working environment is dusty and muddy, if it is not cleaned in time, impurities can easily enter the sealing cavity with the extension and retraction of the piston rod, causing scratches on the seals (general scenarios can be wiped weekly).
Hydraulic oil replacement
The cycle is shortened to 3-6 months (3-6 months under general harsh working conditions, and the excavator defaults to "harsh working conditions"), and "engineering machinery special anti-wear hydraulic oil" (such as L-HM46) should be used, which has stronger anti-emulsification and anti-foaming properties than general hydraulic oil and can adapt to the oil agitation caused by the frequent start and stop of the excavator.


Seal maintenance
The seal material needs to be upgraded to "polyurethane + fluororubber composite structure" (general purpose optional nitrile rubber). Because the oil temperature of excavators is higher (up to 70-80℃, general purpose is 30-60℃), the composite seal can withstand high temperature and reduce leakage. The replacement cycle is usually 1.5-2 years (general purpose 2-3 years).


